As a workaround, setting the Host Checker interval to 0 for the 'Perform check every x minutes' value will prevent sessions from being terminated. He can't stay connected for no more than 20 minutes. This issue is fixed in the following releases: PCS version 8.1R11 and up. Remote Desktop Services: Session has been disconnected: Source Network Address: Laptop's IP AddressĮvent 24, TerminalServices-LocalSessionManager - 1:52:20pm Remote Desktop Services: Session reconnection succeeded: However, clearing those ports didn't stop him from disconnecting.Įvent 25, TerminalServices-LocalSessionmanager - 1:47:14pm While everyone is logged off and am able to let it reboot. I ran the "fix-it" and it deleted all of the inactive ports. Setting Up Remote Desktop For modern versions of Windows, a remote desktop client called Remote Desktop Connection is available in the Start Menu.
I checked the registry and found there were over 500 inactive ports. When finished, disconnect from the UTK VPN using Pulse Secure. (Refer to Figure 1.) The credentials are used to authenticate the user on the remote host, bypassing the WinLogon step.
PULSE SECURE CLIENT DISCONNECT WHEN RDP WINDOWS
User clicks on a terminal service bookmark and is prompted for credentials with a Windows security pop up. I found an article with similar errors that pointed to inactive ports as the culprit. bookmark and the RDP session is established displaying the normal WinLogon screen on the remote host. He remains connected to the network, just not to the server.Įvent ID 1105 - The multi-transport connection has been disconnected. We specify the IP address and DNS settings so they are on the same network as the server.
We only use IPv4 so we have IPv6 unchecked. He will connect for about 5 - 10 minutes and then get disconnected.Įvent ID 1026 - RDP Client ActiveX has been disconnected (Reason = 516) - Remote Desktop can’t connect to the remote computer for one of these reasons: 1) Remote access to the server is not enabled 2) The remoteĬomputer is turned off 3) The remote computer is not available on the network Make sure the remote computer is turned on and connected to the network, and that remote access is enabled.īut he is able to connect so we know that remote access is enabled, the remote computer is not turned off (it's the main file server - never off), and the remote computer is available on the network or he would have never connected to get disconnected.Įvent ID 226 - RDP Client_TCP: An error was encountered when transitioning from TcpStateConnectingTransport to TcpStateDisconnected in response to TcpEventConnectionTimeout (Error code:0X80004004) He was working fine for a while then all of a sudden started getting kicked off.
PULSE SECURE CLIENT DISCONNECT WHEN RDP WINDOWS 10
I have a user that uses his Windows 10 laptop to connect to the Windows 2008 R2 server using remote desktop.